Linear Algebra/Topic: Analyzing Networks

Template:Navigation The diagram below shows some of a car's electrical network. The battery is on the left, drawn as stacked line segments. The wires are drawn as lines, shown straight and with sharp right angles for neatness. Each light is a circle enclosing a loop.

The designer of such a network needs to answer questions like: How much electricity flows when both the hi-beam headlights and the brake lights are on? Below, we will use linear systems to analyze simpler versions of electrical networks.

For the analysis we need two facts about electricity and two facts about electrical networks.

The first fact about electricity is that a battery is like a pump: it provides a force impelling the electricity to flow through the circuits connecting the battery's ends, if there are any such circuits. Template:AnchorWe say that the battery provides a potential to flow. Of course, this network accomplishes its function when, as the electricity flows through a circuit, it goes through a light. For instance, when the driver steps on the brake then the switch makes contact and a circuit is formed on the left side of the diagram, and the electrical current flowing through that circuit will make the brake lights go on, warning drivers behind.

The second electrical fact is that in some kinds of network components the amount of flow is proportional to the force provided by the battery. Template:AnchorThat is, for each such component there is a number, its resistance, such that the potential is equal to the flow times the resistance. The units of measurement are: potential is described in volts, the rate of flow is in amperes, and resistance to the flow is in ohms. These units are defined so that $\text{volts}=\text{amperes}\cdot \text{ohms}$.

Template:AnchorComponents with this property, that the voltage-amperage response curve is a line through the origin, are called resistors. (Light bulbs such as the ones shown above are not this kind of component, because their ohmage changes as they heat up.) For example, if a resistor measures $2$ ohms then wiring it to a $12$ volt battery results in a flow of $6$ amperes. Conversely, if we have electrical current of $2$ amperes through it then there must be a $4$ volt potential difference between its ends. Template:AnchorThis is the voltage drop across the resistor. One way to think of a electrical circuits like the one above is that the battery provides a voltage rise while the other components are voltage drops.

Template:AnchorThe two facts that we need about networks are Kirchhoff's Laws.

• Current Law. For any point in a network, the flow in equals the flow out.
• Voltage Law. Around any circuit the total drop equals the total rise.

In the above network there is only one voltage rise, at the battery, but some networks have more than one.

For a start we can consider the network below. It has a battery that provides the potential to flow and three resistors (resistors are drawn as zig-zags). Template:AnchorWhen components are wired one after another, as here, they are said to be in series.

By Kirchhoff's Voltage Law, because the voltage rise is $20$ volts, the total voltage drop must also be $20$ volts. Since the resistance from start to finish is $10$ ohms (the resistance of the wires is negligible), we get that the current is $(20/10)=2$ amperes. Now, by Kirchhoff's Current Law, there are $2$ amperes through each resistor. (And therefore the voltage drops are: $4$ volts across the $2$ oh m resistor, $10$ volts across the $5$ ohm resistor, and $6$ volts across the $3$ ohm resistor.)

The prior network is so simple that we didn't use a linear system, but the next network is more complicated. Template:AnchorIn this one, the resistors are in parallel. This network is more like the car lighting diagram shown earlier.

We begin by labeling the branches, shown below. Let the current through the left branch of the parallel portion be $i_1$ and that through the right branch be $i_2$, and also let the current through the battery be $i_0$. (We are following Kirchoff's Current Law; for instance, all points in the right branch have the same current, which we call $i_2$. Note that we don't need to know the actual direction of flow— if current flows in the direction opposite to our arrow then we will simply get a negative number in the solution.)

The Current Law, applied to the point in the upper right where the flow $i_0$ meets $i_1$ and $i_2$, gives that $i_0=i_1+i_2$. Applied to the lower right it gives $i_1+i_2=i_0$. In the circuit that loops out of the top of the battery, down the left branch of the parallel portion, and back into the bottom of the battery, the voltage rise is $20$ while the voltage drop is $i_1\cdot 12$, so the Voltage Law gives that $12i_1=20$. Similarly, the circuit from the battery to the right branch and back to the battery gives that $8i_2=20$. And, in the circuit that simply loops around in the left and right branches of the parallel portion (arbitrarily taken clockwise), there is a voltage rise of $0$ and a voltage drop of $8i_2-12i_1$ so the Voltage Law gives that $8i_2-12i_1=0$.

$\begin{array}{ccccccc}{i}_0& -& i_1& -& i_2& =& 0\\ -i_0& +& i_1& +& i_2& =& 0\\ & & 12i_1& & & =& 20\\ & & & & 8i_2& =& 20\\ & & -12i_1& +& 8i_2& =& 0\end{array}$

The solution is $i_0=25/6$, $i_1=5/3$, and $i_2=5/2$, all in amperes. (Incidentally, this illustrates that redundant equations do indeed arise in practice.)

Kirchhoff's laws can be used to establish the electrical properties of networks of great complexity. Template:AnchorThe next diagram shows five resistors, wired in a series-parallel way.

Template:AnchorThis network is a Wheatstone bridge (see Problem 4). To analyze it, we can place the arrows in this way.

Kirchoff's Current Law, applied to the top node, the left node, the right node, and the bottom node gives these.

$\begin{array}{cc}{i}_0& =i_1+i_2\\ i_1& =i_3+i_5\\ i_2+i_5& =i_4\\ i_3+i_4& =i_0\end{array}$

Kirchhoff's Voltage Law, applied to the inside loop (the $i_0$ to $i_1$ to $i_3$ to $i_0$ loop), the outside loop, and the upper loop not involving the battery, gives these.

$\begin{array}{cc}5i_1+10i_3& =10\\ 2i_2+4i_4& =10\\ 5i_1+50i_5-2i_2& =0\end{array}$

Those suffice to determine the solution $i_0=7/3$, $i_1=2/3$, $i_2=5/3$, $i_3=2/3$, $i_4=5/3$, and $i_5=0$.

Networks of other kinds, not just electrical ones, can also be analyzed in this way. For instance, networks of streets are given in the exercises.

Exercises

Many of the systems for these problems are mostly easily solved on a computer.

There are networks other than electrical ones, and we can ask how well Kirchoff's laws apply to them. The remaining questions consider an extension to networks of streets.

/Solutions/